A flagship page for the water inlet node: filtration, pressure reduction, backflow protection, backwash automation, drainage and service access for apartments, houses, pools, spa areas and commercial properties.
We build a neat water inlet node for the property: filtration, pressure reduction, backflow protection, backwash automation and service access work together as one clear system for stable water and easy operation.
The assembly usually includes a filter, pressure reducer, check or backflow protection device, shut-off valves, gauges, a drain for backwashing and space for service access. The exact composition depends on the property and task.
We check inlet diameter, pressure before and after reduction, design flow, consumption pattern, EN 1717 requirements, drain type, installation space in the plumbing cabinet or technical room, and service access.
Equipment selection, node layout, removal of the old assembly if required, installation, drain connection, reducer setting, reverse rinsing, leak test, commissioning and maintenance briefing.
Below are the main equipment groups used to build a neat and serviceable water inlet node.
Reverse-rinsing filters for apartment, house, pool and commercial inlet nodes. F76S is commonly used on threaded domestic inlets, while F78TS covers larger flanged inlets and higher flow rates.
Pressure reducing valves for stabilising downstream pressure. D06F is common for apartments and small houses, while D15S is used on larger inlet nodes and higher-capacity engineering assemblies.
Protective devices for separating potable and technical water according to the engineering task and EN 1717 requirements. BA295S is used on threaded nodes, BA300 on larger flanged lines.
Automation for reverse rinsing of compatible filters and contamination control by differential pressure. Useful where a predictable service routine is required without constant manual intervention.
A proper inlet node is not a single device but the correct sequence of components: filtration, pressure reduction, backflow protection, gauge control, drainage and service access. This complete assembly is what we install turnkey on site.
Compact cold/hot water inlet before the manifold, leak protection, mixers, water heater and household equipment.
Boiler room or technical room: protection of sanitary fixtures, boiler room, DHW system, pool and utility lines.
Make-up water nodes, protection of heat exchangers, automation and water treatment equipment.
Offices, restaurants, technical zones and rooms where a stable inlet and a clear service routine are required.
Send a photo of the existing assembly, inlet size, pressure and the task: new installation, replacement, pressure reduction, backflow protection, backwash automation or a complete inlet node. We will select the composition, models and installation sequence.
Hanwell Brauckmann filters have their own page with product lines and versions. Here the focus stays on the complete water inlet: what to place at the entry point, how to arrange it neatly and how to keep the system easy to service.
